Learn
Learn spectrum analyzers
A spectrum analyzer shows which frequencies are in a sound or a radio signal and how strong each one is. These short guides and hands-on playgrounds teach you to read one, step by step, using your own voice and the live spectrum analyzer. No maths needed, and nothing to install.
Start here
- What Is a Spectrum Analyzer?What a spectrum analyzer shows, what it is for and how it works, with a live demo.
- How to Read a Spectrum AnalyzerRead the Hz and dB axes, peaks, harmonics and the noise floor, with demo sounds.
- Spectrum Analyzer vs OscilloscopeTime domain or frequency domain: what each shows and when to use which.
- Glossary60 audio and RF terms in plain words, from A-weighting to VSWR.
Go deeper
- Spectrum Analyzer SettingsFFT size, RBW, span, averaging and windows: what each setting changes.
- FFT ExplainedHow an FFT turns a wave into frequencies, with pictures instead of maths.
- FFT & Sampling CalculatorBin width, frame length and aliasing from the sample rate and FFT size.
- Window Function ExplorerCompare Hann, Blackman, flat-top and other FFT windows side by side.
- Fourier PlaygroundAdd sine waves and watch the wave and its spectrum change, then listen.
Buy
A 15-minute learning path
Follow these steps in order. Each one takes a few minutes, and each builds on the one before. Keep the live analyzer open in a second tab so you can try things as you read.
- Find out what it is (3 minutes). Read What is a spectrum analyzer? It explains the two axes in one picture: low to high pitch from left to right, quiet to loud from bottom to top.
- Hum and whistle (2 minutes). Open the live analyzer, press Listen and hum one steady note. One tall peak appears, with smaller peaks at two, three and four times its frequency. Now whistle: a single thin peak, much higher up, often between 1 and 3 kHz.
- Read the graph properly (4 minutes). Work through How to read a spectrum analyzer. It shows you how to find the strongest frequency, how to tell a real peak from the noise floor, and what hum, harmonics and clipping look like.
- Time or frequency? (2 minutes). Read Spectrum analyzer vs oscilloscope and play its demo. You see the same sound twice: as a wave over time, and as a set of frequencies.
- Change the settings (2 minutes). Spectrum analyzer settings covers FFT size and averaging. On the live analyzer, switch the FFT from 2,048 to 16,384 and watch the peaks get thinner but slower.
- See inside the FFT (2 minutes). Build a square wave from sine waves in the Fourier playground, then compare windows in the window function explorer. Read FFT explained when you want the full story.
After that, you know enough to use every tool on this site. When a word puzzles you, look it up in the glossary.
Words you will meet
Five words come up again and again. Learn these and the rest of the guides read easily.
- Hz (hertz)
- How many times a second something repeats. A low bass note is about 40 Hz, a voice sits from about 100 Hz to 4 kHz, and 1 kHz means 1,000 times a second.
- dBFS
- Decibels below full scale: the loudest level a digital system can hold is 0 dBFS, so every real reading is a minus number. −6 dBFS is about half the biggest possible wave.
- FFT
- The Fast Fourier Transform, the maths that turns a short piece of wave into a list of frequencies. Every analyzer on this site runs one many times a second.
- Noise floor
- The low, uneven line along the bottom of the graph. Anything that does not stand clearly above it is too weak to measure.
- Harmonic
- A copy of a tone at two, three, four or more times its frequency. A 110 Hz guitar string also gives peaks at 220, 330 and 440 Hz.
How the lessons work
Every demo runs in your browser. When you press Listen, the sound from your mic is measured on your own device and never uploaded, and nothing is saved unless you press save. If you would rather stay quiet, every demo also has a built-in test sound. The pages work on phones, tablets and laptops, so a class can follow along on whatever they have.
FAQ
I am new. Where do I start?
Read What is a spectrum analyzer? first. Then open the live analyzer and follow How to read a spectrum analyzer with your own voice.
Do I need maths?
No. The guides use plain words and pictures. The FFT and window pages show the maths only as an extra, for people who want it.
Are the lessons free?
Yes. Every guide and playground is free, with no sign-up and no account.
Can I use these for teaching?
Yes. Link to any page you like. The playgrounds work on classroom laptops and phones, and no sound or file ever leaves the device.